Dual Sensor Reversing Camera for Motorhomes

• Compact and stylish dual-lens reversing camera
• Fast-mount click attachment of the camera main unit to the mounting plate
• Cam1 sensor with 50° and Cam2 sensor with 95° horizontal viewing angle
• Vertical and horizontal image section of Cam1 and Cam2 are manually adjustable on the camera housing
• IR-LED night illumination system for Cam2 with dynamic LDR brightness control
• Integrated microphone (Cam2)
• 3-piece separable system cable with 17.0 m main cable length
• Adaptation to factory-installed Waeco main cables included in the set

The ZENEC ZE-RVSC200-MK2 dual-lens reversing camera was specially developed for semi-integrated and fully integrated motorhomes. The upper part of the camera housing contains the so-called Cam1. Its main function is to replace the missing interior mirror. The camera lens located in the lower part is called Cam2 and is primarily intended for reversing. It displays the individually adjustable area of up to 5 meters behind the motorhome. The Cam2 is supported by both the integrated microphone and the IR LED night vision system. This product is compatible with a selection of aftermarket 2-DIN A/V devices and models from the ZENEC E>GO product line that have two camera inputs and one microphone input. Further specifications: Image sensor Cam1 + Cam2: 6.09 mm SONY IMX225LQR CMOS sensor; Lens focal length Cam1/Cam2: f3.5 / f2.3; TV system: NTSC / 30 fps; Viewing angle Cam1/Cam2: 90°(D)x50°(H)x45°(V) / 130°(D)x95°(H)x75°(V); Native sensor Resolution: 1305 (H) x 977 (V) pixels Output signal resolution: > 420 TV lines Refresh rate: 30 frames/sec. Signal-to-noise ratio: > 48 dB Light sensitivity: 0.3 lux Video output: 1.0 Vp-p, 75 Ohm CVBS White balance: Automatic Exposure compensation: Automatic Gamma correction: 0.45 Brightness adjustment: Automatic Synchronization: Automatic Power supply: DC 12 V Power consumption: 70 mA / 100 mA @12VDC, ≤ 2040 mW Protection class: IP69K Operating temperature: -30°C ~ +75°C, RH 95% Max.