Universal Trekfinder fender flares - 50 mm

Виды доставок

• Выбрать из магазина (если товары на месте) 0 €
• Omniva посылки от € 5
• Доставка по всей Европе от € 7

Тех поддержка

+371 22 32 71 19 рабочие дни с 10:00 до 18:00 (GMT+2)
Позвоните нам, для получения дополнительной информации об этом продукте! Предварительно подготовьте номер товара (который указан выше)

Виды оплат

• Банковское перечисление

Universal Trekfinder fender flares - 50 mm

70.15€

Без НДС: 57.98€

Остаток на складе в Риге: 5-9 рабочих дней
MPN: 912166

✓ Полностью новый продукт

Перевести на

Описание

Width: 50 mm
Material: Rubber
Color: Black
Length: 3 m

Affordable and flexible fender flares of very good quality
Durable fender flares made of black rubber
Ideal for e.g. For example, for wheel spacers, wheel spacers, etc. - for required registration or off-road use. The fender flares are glued in the wheel well under the body's flange. The factory-applied backing film is removed, and the flare can be securely glued to the clean surface/fender flange. For challenging off-road use, additional screw fixing of the flare is recommended. The flare is 70 millimeters wide in total - 20 millimeters are used for mounting, and 50 millimeters protrude outwards to cover the tires. Fender flare, black, soft, 50 mm wide, 3 m long, including TÜV certification. The flare is 70 millimeters wide in total - 20 millimeters are used for mounting, and 50 millimeters protrude outwards to cover the tires. Ideal for... For example, when widening the track using wheels, spacers, etc. – for required registration or off-road use. The widening pieces are glued inside the wheel well, under the body's inner lip. Additional fixing with screws is recommended.

Installation Instructions:
- The mounting surface must be smooth, rust-free, thoroughly cleaned, and grease-free.
- The ambient temperature and the temperature of the components or mounting surface at the time of installation and for a period of 24 hours afterward must be at least 20° Celsius.
- After removing the 3M tape backing film, the extension must be pressed evenly onto the mounting surface with high pressure for approximately 1 minute.
- Adjust the ends of the extension to your liking with a sharp utility knife to match the vehicle's appearance.
- Please leave the vehicle standing for at least 24 hours after installation, preferably 48 hours.
- The adhesive will only reach its final strength after 48 hours.
- Please do not wash the vehicle for at least 48 hours.
- In some installation situations, especially if the installation instructions cannot be followed, a Additional fastening using, for example, self-tapping screws, body adhesive, or primer is recommended.

В корзину

Купить сразу Спросить про этот товар

В закладки В сравнение